ABB i-bus® KNX PARAMETERS
—
7.9.3.1.6
DEPENDENT PARAMETER
Delay time for drive
This parameter can be used to define whether the default delay times or the user-defined delay times
are to be used.
More information → Start-up and coasting delay and minimum run time, Page 88.
Options
Default
Custom
Options
Default
Custom
Condition for visibility:
Parameter window Drive \ Parameter Parameter setting \ Option Individual
—
7.9.3.1.6.1
DEPENDENT PARAMETER
Start-up delay
This parameter can be used to define the duration of start-up delay.
Options
0 ... 999 ms
Condition for visibility:
Parameter window Drive \ Parameter Parameter setting \ Option Individual \ Parameter Delay time for
drive \ Option Custom
The following values are used:
•
Start-up delay: 0 ms
•
Coasting delay: 0 ms
•
Minimum run time for drive: 50 ms
The values can be set individually.
The default settings need to be changed only if the blind/shutter is to be positioned very exactly.
•
Start-up delay
•
Coasting delay
•
Minimum run time for drive
If changes are made to these parameters in the user-defined setting, then the technical data of the
respective drive manufacturer must be observed.
•
Start-up delay
•
Coasting delay
•
Minimum run time for drive
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 143