ABB i-bus KNX Product Manual page 160

ABB i-bus® KNX PARAMETERS
—
7.9.5.1.1.1.1
DEPENDENT PARAMETER
Scene assignment
This parameter can be used to define which scene number is retrieved.
The scene assignment must be defined in Parameter window Scene assignments, in the parameter En-
able scene assignment x.
Options
1 ... 16
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to wind alarm x \ Option Yes \ Parameter Position on wind alarm \ Option Scene assignment
—
7.9.5.1.1.1.2
DEPENDENT PARAMETER
Position height (0 % = top; 100 % = bottom)
This parameter can be used to define the position to which the blind/shutter is moved.
The position will be approached only with deactivated automatic sun protection.
Options
0 ... 100 %
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to wind alarm x \ Option Yes \ Parameter Position on wind alarm \ Option Individual position
—
7.9.5.1.1.1.3
DEPENDENT PARAMETER
Position slat (0 % = open; 100 % = closed)
This parameter can be used to define the position to which the blind/shutter slats are moved.
The position will be approached only with deactivated automatic sun protection.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
0 ... 100 %
Condition for visibility:
Parameter window Safety/Weather \ Parameter Parameter setting \ Option Individual \ Parameter Out-
put reacts to wind alarm x \ Option Yes \ Parameter Position on wind alarm \ Option Individual position
Note
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 160