ABB i-bus KNX Product Manual page 47

ABB i-bus® KNX PRODUCT OVERVIEW
3.8 Switch/Shutter Actuator SAH/S 24.10.7.1
Fig. 16: Device illustration SAH/S 24.10.7.1
The Switch/Shutter Actuator is a modular installation device in proM design. The device is designed for
installation in electrical distribution boards and small housings for rapid mounting on a 35-mm mount-
ing rail (to EN 60715).
The device possesses mutually independent switching relays with which the following functions can be
implemented:
• Switching electric consumers (individually)
• Activation of 230 V AC blind and shutter drives (in pairs)
The device does not possess any mutually electromechanically interlocked output contacts.
The device is provided with bus voltage via the ABB i-bus® KNX. The connection to the ABB i-bus® KNX is
implemented using the bus connection terminal. The consumers are connected at the outputs using
screw terminals (terminal designation on the housing).
Manual operation mode permits on-site operation of the device using a membrane keypad.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 47