Siemens 7KG6000-8AA Operating Instructions Manual page 26

Output 2
Output 1
Jumper positions:
load-independent current
To change the jumper positions, the following instructions must
be observed:
•
Short circuit the ct's if required.
•
To remove lid from case insert a flat screwdriver approx.
0.8 * 3.5 mm with an angle of 45° into one after another of the
locking hooks and twist the screwdriver by approx. 45°.
Make a note of the location if necessary.
•
Pull the modules half-way out by slightly moving them back and
forth.
•
Change the jumper positions as required.
•
Plug the modules back into the device
(position the power supply in the middle slot).
•
Snap the cover back into its correct position.
26
Output 3
Terminals
SIMEAS
Output 2
Output 1
Jumper positions:
load-independent voltage
E50417-K109U-C322-A1
Output 3