Parameter Assignment; Parameterization With Script; Parameterization With Free Function Blocks - Siemens SINAMICS S120 Manual

8.24.4

Parameter assignment

8.24.4.1

Parameterization with script

A script can be used for the automatic parameterization, which automatically makes the
parameter settings in STARTER. The script and the handling instructions for executing the
script are provided on the customer DVD, which is supplied with the device when it is
shipped.
Note
Script
The script and the handling instructions for executing the script are provided on the customer
DVD in folder "99 SOFTWARE\SCRIPT_option_L34". The customer DVD is supplied with
the device when it is shipped.
8.24.4.2

Parameterization with free function blocks

The free function blocks are used for the parameterization described in this section. You
must start by activating them.
Activating the free function blocks
To be able to work with the free function blocks, they must first be activated/enabled:
● If you are not certain that the project in the STARTER corresponds to the drive
● In Offline mode -> Right-click the drive object -> Properties -> Activate the "Free function
● You will then need to perform a download (load data to the target device) so that the
Cabinet Modules
Manual, (GH5), 05/2010, A5E03263538A
configuration, you should start with an upload (load data to PG).
blocks" in the "Drive Properties" interactive screenform under "Select function modules".
"Free function blocks" function module is activated in the drive.
8.24 L34, output-side circuit breaker
Options
409