Did / Tie Wink Time Out Assignment - Panasonic KX-TD816 Programming Manual

[435] DID / TIE Wink Time Out Assignment

Description
The DID / TIE outgoing method can be set to the wink mode in programme [432] DID / TIE
Outgoing Assignment. This programme sets the time the system waits for the confirmation
wink signal after an outside line is seized according to your central office service.
Selection
• DID / TIE format number: 1 through 8,
• Time: 1 through 127 (
Default
All DID / TIE formats – 16
Programming
1.
Enter 435.
Display: 435 WINK TIMEOUT
2.
Press NEXT.
Display: Format NO?
3.
Enter a DID / TIE format number.
To enter DID / TIE format number 1, you can also press NEXT.
Display example: 1:16
4.
Enter the time.
To change the current entry, press CLEAR and enter the new number.
5.
Press STORE.
6.
To programme another DID / TIE format, press NEXT or PREV, or SELECT and the
desired DID / TIE format number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• You cannot leave the entry empty.
• To assign all DID / TIE formats to one selection, press the
display shows the contents programmed for DID / TIE format number 1.
Features Guide References
Direct Inward Dialling (DID)
General Programming
( =all DID / TIE formats)
64 milliseconds is the actual time)
2.5 Outside Line Programming
key in step 3. In this case, the
205