ABB COM600 series User Manual page 42

42
COM600 series, version 4.1
User's Manual
By default, response to the ping command is blocked by the
firewall. To allow ping response, change the Allow incoming
echo requests configuration setting in the firewall's Advanced
ICMP Settings.
Table 5.5.1-1 shows the default IP addresses for the LAN ports.
Table 5.5.1-1 Default IP addresses for the LAN ports
LAN Port Gateway
LAN 1 Not defined
LAN 2 Not defined
Some tasks, for example changing the IP addresses or adding users, require access directly
to the COM600 computer either locally or via the remote desktop software.
Accessing the COM600 computer:
•
Locally by connecting a USB keyboard, a USB mouse, and a display to the computer.
•
Remotely with the remote desktop program via LAN. By default the security settings
allow the remote desktop connection only via the interface reserved for the local
use.
Regional settings
The default regional setting is English (United States).
Remote desktop
You can use the COM600 computer as a local console from an engineering computer
with remote desktop.
The COM600 computer can be restarted remotely by running restart.bat command from
the root of C drive.
Due to security reasons, the remote desktop access to COM600 computer is by default
disabled. To allow remote desktop access, you must enable and configure the settings
in the COM600 computer.
To allow remote desktop access:
1. In COM600 computer select Start -> Control Panel -> System.
2. In the System Properties dialog, select Remote tab page.
3. Select the Remote desktop access check-box.
Mask IP Address
255.255.255.0 192.168.2.11
255.255.255.0 10.0.0.11
1MRS756125
Local Area Con-
nection (Local)
Local Area Con-
nection (Remote)