Siemens SIMATIC S7-1500 System Manual page 197

M enu icons
The following table shows the icons that are displayed in the menus.
Table 12- 3
Ico n
Handling the front cover
The front cover is pluggable. You can remove or replace the front cover during operation
(RUN). Removing or replacing the front cover has no effect on the running CPU.
To remove the front cover from the CPU, follow these steps:
1. Flip up the front cover until the front cover stands at a 90° angle to the front of the
module.
2. In the upper area of the front cover simultaneously press on the anchor(s) and pull the
front cover forward and away.
Automation system
System Manual, 09/2016, A5E03461182-AD
Menu icons
Me aning
Editable menu item.
Select the desired language here.
A message is available in the next lower level page.
There is an error in the next lower level page.
The marked module is not accessible.
Navigate to the next lower level page.
In edit mode you make the selection using two arrow keys:
down/up: jumps to the selection or is used to select the desired digits/options.
•
In edit mode you make the selection using four arrow keys:
down/up: jumps to the selection or is used to select the desired digits.
•
left/right: jumps one spot forward or backward.
•
The alarm is not yet acknowledged.
The alarm is acknowledged.
CPU display
197