Dimension drawings
A.8 Dimension drawings of the labeling strips
A.8
Dimension drawings of the labeling strips
Figure A-13
Figure A-14
A.9
Dimension drawing of test probe for measurement tap
To perform measurements on the front connector of the S7-1500/ET 200MP automation
system, you need a test probe with the following properties:
● Maximum diameter at measuring tip: 1 mm
● Length of measuring tip: ≥ 10 mm
Figure A-15
Corresponding test probes are available from electrical retailers.
252
Dimension drawing of labeling strips for 35 mm modules
Dimension drawing of labeling strips for 25 mm modules
Dimension drawing of test probe for measurement tap
Automation system
System Manual, 09/2016, A5E03461182-AD