Removing/Inserting A Simatic Memory Card On The Cpu - Siemens SIMATIC S7-1500 System Manual

Requirements: CPU as bus device
Note the following requirements for operation of a CPU as bus device:
● PROFIBUS interface
– The integrated PROFIBUS interface of the CPU is configured using STEP 7 (device
– The CPU is connected to the subnet.
– The terminating resistors at the segment boundaries are switched on.
See the PROFIBUS Function Manual
(http://support.automation.siemens.com/WW/view/en/59193579)
● PROFINET interface
– The integrated PROFINET interface of the CPU is configured using STEP 7
– The CPU is connected to the subnet.
See the PROFINET Function Manual
(http://support.automation.siemens.com/WW/view/en/49948856)
10.3.1

Removing/inserting a SIMATIC memory card on the CPU

Requirements
The CPU only supports pre-formatted SIMATIC memory cards. If applicable, delete all
previously stored data before using the SIMATIC memory card. Additional information about
deleting the contents of the SIMATIC memory card can be found in the section SIMATIC
memory card - overview (Page 187).
In order to work with the SIMATIC memory card, first ensure that the SIMATIC memory card
is not write-protected. For this purpose, slide the slider on the SIMATIC memory card out of
the lock position.
If the inserted SIMATIC memory card is write-protected, the CPU display outputs the
symbol in the "Memory card" menu under "Overview" and writes a corresponding alarm to
the lower level of the menu.
Automation system
System Manual, 09/2016, A5E03461182-AD
10.3 Procedure for commissioning the S7-1500 automation system
address and bus parameters configured).
(IP address and device name configured).
Commissioning
165