Commissioning Procedure; Removing/Plugging In A Simatic Memory Card - Siemens SIMATIC S7-1500 System Manual

Commissioning

11.3 Commissioning procedure

11.3 Commissioning procedure
11.3.1

Removing/plugging in a SIMATIC memory card

Requirements
The SIMATIC Drive Controller only supports pre-formatted SIMATIC memory cards. If
applicable, delete all previously stored data before using the SIMATIC memory card.
In order to work with the SIMATIC memory card, first ensure that the SIMATIC memory card
is not write-protected. For this purpose, slide the slider on the SIMATIC memory card out of
the lock position.
Inserting the SIMATIC memory card
To insert a SIMATIC memory card, follow these steps:
1. Open the lower cover of the SIMATIC Drive Controller.
2. Ensure that either the SIMATIC Drive Controller is switched off or that the CPU is in
STOP.
3. Insert the SIMATIC memory card, as depicted on the SIMATIC Drive Controller, into the
slot for the SIMATIC memory card.
①
②
③
4. Carefully push the SIMATIC memory card into the slot until the SIMATIC memory card
clicks into place.
192
ACT LED
SIMATIC memory card
Symbol shows correct position of the SIMATIC memory card
SIMATIC Drive Controller
System Manual, 11/2019, A5E46600094-AA