Mounting The Simatic Drive Controller - Siemens SIMATIC S7-1500 System Manual

5.2

Mounting the SIMATIC Drive Controller

Requirement
The SIMATIC Drive Controller is fitted in a control cabinet together with the SINAMICS
components.
Requirements for installing a SIMATIC Drive Controller:
● The control cabinet has been installed and wired.
● The SINAMICS components have been installed and wired.
● The components and tools required for installation are to hand.
● T10 screwdriver for the M3 screws in the spacer are to hand.
● For installation on the control cabinet wall: Tool for M6 screws
Designs
The SIMATIC Drive Controller is fitted to the wall of the control cabinet in one of the following
ways:
● Installation with spacer
● Installation without spacer
The SIMATIC Drive Controller is supplied with a spacer fitted.
The spacers increase the depth of the SIMATIC Drive Controller to 270 mm and allow flush
installation with 270 mm-deep power units.
Installing SIMATIC Drive Controller with spacers
Proceed as follows:
1
SIMATIC Drive Controller
System Manual, 11/2019, A5E46600094-AA
Attach the SIMATIC Drive Controller to the
control cabinet wall with one M6 screw
① ②
each at and .
Tightening torque: 6 Nm (53.1 lbf in)
5.2 Mounting the SIMATIC Drive Controller
Installation
69