Siemens SIMATIC S7-1500 System Manual page 71

Installation
5.2 Mounting the SIMATIC Drive Controller
Installing SIMATIC Drive Controller without spacers
Proceed as follows:
1
2
Note
If you install multiple SIMATIC Drive Controllers or SINAMICS S120 CU320-2 next to one
another, use a grid size of 50 mm for the drilled holes horizontally to compensate for
tolerances. A dimension drawing of the SIMATIC Drive Controller is available in the SIMATIC
Drive Controller manual (https://support.industry.siemens.com/cs/ww/en/view/109766666).
70
Uninstalling the spacer:
Unscrew the M3 screws
•
move the space.
Tighten the M3 screws
•
Attach the SIMATIC Drive Controller to the
control cabinet wall with one M6 screw
① ②
each at and .
Tightening torque: 6 Nm (53.1 lbf in)
①
and re-
①
again.
SIMATIC Drive Controller
System Manual, 11/2019, A5E46600094-AA