Hitachi IJ UX Service Manual page 215

②
Heat the filled part by a warm air of a drier (500W equivalent) for 7 to 8 minutes
and cure the surface.
Caution ： Keep the drier 50 to 100mm away so as not to deform the tube by
keeping it too close.
Knack of infusing the
When infusing the silicone into the dispenser, perform it as shown below (to
purge air).
シリコン注入のコツ
Metallic needle
Place the needle on
the upside
Downside is NG
Place the needle on
the upside
ディスペンサの保管
Storage of the dispenser
If left as-is after use, the silicone hardens in the metallic needle portion of the
dispenser. Plug it by using a clip and so on.
９ Push "Beam adjustment" on the "Circulation control screen" to adjust the position of the ink beam.
１０
Perform ink drop.
１１
Perform the auto phase gain adjustment.
Drier
50 to 100mm
Nozzle
Cylinder
Cylinder
Push the piston as if to purge air
Clip
5-21
Put the silicone in
Wait until the silicone comes
down to the piston
Piston