Hitachi IJ UX Service Manual page 36

2 Press Level sensor confirmation.
The level sensor confirmation screen is then displayed.
Adjust./oper. checkout
<Level sensor confirmation>
<Main ink tank>
Too high [OF]
undetected
Initial [１]
detected
Container
Level sensor
type
Too high [OF]
Main
ink tank
Initial level [１]
Sensor [１]
Ink
Sensor [２]
reservoir
Sensor [３]
Sensor [WHITE]
(Float : UPPER)
Makeup
reservoir
Sensor [RED]
(Float : LOWER)
[Note] When the printer is in "Stop" state, and "High Temperature Print Control" is set to "Enable",
the dialog box shown below will be displayed in place of "Initial [1]" of <Main ink tank> on
the screen. (Refer to "6.17 High Temperature Print Control" in Technical Manual.)
When High Temperature Print Control is set to "Enable", Sensor [2] will represent the initial
level. When High Temperature Print Control set to "Disable", Sensor [1] will represent the
initial level instead.
Sensor [１]
detected
Sensor [２]
detected
Sensor [３]
detected
[Stop ]
<Ink reservoir> <Makeup reservoir>
Sensor [１] Sensor [□]
detected
detected
Sensor [２]
detected
Sensor [３] Sensor [■]
detected detected
Proc. status: In progress
Undetected
The sensor is not detecting
"overflow" level.
The sensor is not detecting the
level.
The sensor is not detecting the
level.
The sensor is not detecting the
level.
"Ink Low Warning" is appears.
The sensor is not detecting the
level.
"Makeup Low Warning" is
appears.
The float is located at lower side
and "Sensor [RED]" is ON.
2-16
Com=0 2015.07.07 12:45
Back
Detected
The sensor detected "overflow"
level. (Abnormal)
The sensor detected the level.
Ink is present.
(Cartridge replacement can NOT be made)
Ink is present.
(Cartridge replacement can NOT be made)
Ink is present.
(Cartridge replacement can be made)
Makeup is present.
(Cartridge replacement can NOT be made)
The float is located at upper
side and "Sensor [WHITE]" is
ON.
Makeup is present.
(Cartridge replacement can be made)
WHITE
RED
Back