Siemens SINUMERIK 840D SL Operating Manual page 313

Procedure
Parameter Description
LAB Repeat jump label for position
(only for G code)
PL Machining plane
(only for G code)
Position pattern Selection option for the following patterns:
Line
•
(only for G code)
Grid
•
Frame
•
Z0 (only for Z coordinate of reference point Z (abs)
ShopMill)
X0 X coordinate of the reference point X (abs)
This position must be programmed absolutely in the 1st call.
Y0 Y coordinate of the reference point Y (abs)
This position must be programmed absolutely in the 1st call.
α0 Angle of rotation of the line referred to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Line
L0 Distance of the 1st position to reference point
L Distance between the positions
N Number of positions
Grid or frame
αX Shear angle X
αY Shear angle Y
L1 Distance between columns
L2 Distance between rows
N1 Number of columns
N2 Number of rows
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
1. The part program or ShopMill program to be processed has been
created and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Positions" and "Line" softkeys.
The "Position pattern" input window opens.
Programming technological functions (cycles)
8.1 Drilling
Unit
mm
mm
mm
Degrees
mm
mm
Degrees
Degrees
mm
mm
313