Fujitsu AUYG07LVLA Design & Technical Manual page 201

INSTALLATION
1) Remove the insulation of the remote controller cable.
55
45
30
8
8
8
nsert a at b ade screwdri er and re o e the ront case and rear case b twisting it s ight .
Hooks (2 places)
Flat screwdriver
3) Install the rear case to the wall, box, etc. with 2 screws (M4 × 16 mm). Fix the 2 screws in
either horizontal or vertical position.
A. When mounting on the box:
Attach the case after leading the cable.
Remote controller cable
Box
Rear case
When connecting the remote controller cable, take measures to prevent water or insects
coming into the remote controller through the cable, such as to provide a trap or close the
hole for cabling with putty.
4) Setting up the DIP switch. Refer to "6. SYSTEM DESIGN".
(Unit: mm)
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Rear case
Front case
Screws
CAUTION
Putty
Trap
Putty
Trap
- (05 - 10) -
B. When the cable is along the wall:
Mount the rear case on the wall.
Cut off a hole for cabling in the front case.
Cut off
Putty
Trap
Front case
5. CONTROL SYSTEM