Fujitsu AUYG07LVLA Design & Technical Manual page 281

e o e the contro bo as shown in the figure
and then change the positioning to the opposite
side.
To the opposite side
(7) Attach the bottom panel and secure it with the
screws (4 pieces).
(9) Attach the control box cover and secure it with
the screws (2 places).
Control box
Control box cover
(6) Attach the control box to the main unit as
Remove the control
box by lifting up and
out through slots
Control box
(8) Secure the control box with the screws
Bottom panel
Control box
(10) Attach the wiring cover and secure it with the
- (06 - 33) -
shown in the figure.
The lead wire
runs here
nsert and fi the contro
box using the slots
(4 pieces).
screws (2 places).
fi the sea s on the
fi the sea so each ho e
(4 places) is covered
ain unit p aces .
Secure the wiring
cover by inserting into
the slots
Wiring cover
Seal
(Accessory)
6. SYSTEM DESIGN