Fujitsu AUYG07LVLA Design & Technical Manual page 202

5) Connect the cable to the terminals on the front case. Fix the cable together with the sheath
with the cable tie. Cut off the excess cable tie.
Tightening torque
Terminal screw
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Be careful to avoid breaking the cable by over-tightening the cable tie.
When connecting the remote controller cables, do not over-tighten the screws.
6) Attach the front case.
Insert after adjusting upper part of front case.
When inserting the front case, do not pinch the cable.
Front case
Good No good No good
Insert the upper case firmly. If improperly attached, it will cause the upper case to fall off.
. to .
Cable tie
Remote controller
cable (sheath)
Good
2 mm
(3/32 in.)
CAUTION
Click!
No good
CAUTION
- (05 - 11) -
Hole for cable tie
No good No good
5. CONTROL SYSTEM