Step #1: Enable Dhcp Server (Optional) - D-Link DWC-1000 User Manual

Section 3 - Basic Configuration

Step #1: Enable DHCP Server (Optional)

By default, Dynamic Host Configuration Protocol (DHCP) is disabled on the wireless controller. If you are not
configuring your access points with static IP addresses, set up a DHCP server, or DHCP server relay on the network.
If desired, perform the following procedure to configure your wireless controller to act as a DHCP server.
1. Click Network > LAN > LAN Settings. The LAN Settings page will appear.
2. Under IP Address Setup, change the IP Address and Subnet Mask to values used within your network.
Record the settings; you will refer to them later in this procedure.
3. Click Save.
4. Wait for 60 seconds, and then relaunch your web browser.
5. In the web browser's address field, enter the new IP address you recorded in step 2.
6. Click Network > LAN > LAN Settings.
7. In the LAN Settings page, change DHCP Mode to DHCP Server. This will bring up several new fields
below the DHCP Mode.
8. Complete the fields given below and click Save.
Field
Default Gateway Enter the IP address of the gateway for your LAN.
Domain Name Enter the domain name.
Lease Time Enter the lease time of the assigned IP addresses.
Configure DNS/
Turn this on to enter the IP address of the DNS or WINS server.
WINS
Primary DNS If configured Domain Name System (DNS) servers are available on the LAN, enter the IP address of
Server the primary DNS server.
Secondary DNS
If configured domain name system (DNS) servers are available on the LAN, enter the IP address of
Server the secondary DNS server.
If Windows Internet Name Service (DNS) servers are available on the LAN, enter the IP address of
WINS Server
the WINS server.
D-Link DWC-1000 User Manual
Description
28