Panasonic KX-NS1000 Installation Manual page 148

4.6.3 STACK-S (TDE) Card (KX-NS0132)
LED Indications
STACK-S (TDE) Card
Indication
CARD STATUS
Legacy Gateway
Indication
RUN
ALARM
Installing and Removing a STACK-S (TDE) Card
Before Installing the STACK-S (TDE) Card
Before you install a STACK-S (TDE) card in a PBX that has been used, make a backup of the system data in
case you want to use it later, with another PBX, etc. For details about making a backup, refer to the PC
Programming Manual of the corresponding PBX.
To use the PBX as a legacy gateway, the MPR card must be replaced with a STACK-S (TDE) card.
Note
•
For some PBXs, the appearance of the MPR card and BUS-S card may differ from the following
illustrations.
148 Installation Manual
Color
Green STACK-S (TDE) card status indication
•
Red STACK-S (TDE) card status indication
•
•
Color
Green Status indication for legacy gateway
•
•
•
•
Note
Red Alarm status indication for legacy gateway
•
•
Description
ON: INS (In Service)
ON: Fault
Flashing: OUS (Out of Service)
Description
ON: Normal
OFF: Power off
Slow Flashing: Starting up
Moderate Flashing: STACK-S (TDE) card error
LED flashing patterns are as follows:
•
Slow Flashing: 60 times per minute
•
Moderate Flashing: 120 times per minute
ON: Alarm
OFF: Normal
Document Version 2016-03