Panasonic KX-NS1000 Installation Manual page 171

Note
•
After the PBX is initialized, you can restore system data to the PBX that has been backed up earlier.
For details about backing up and restoring system data, refer to "6.1 Tool—System Data Backup",
"7.2.2 Utility—File—File Transfer PBX to PC" and "7.2.1 Utility—File—File Transfer PC to PBX" in
the PC Programming Manual.
•
After the PBX is initialized, you must set up the mandatory settings required for both stand-alone PBXs
and PBXs in a One-look network with Easy Setup Wizard. For details refer to "Connecting to Web
Maintenance Console" and "5.4.1 Easy Setup Wizard".
•
When a UPS is connected, make sure it is started as instructed in the documentation for the UPS.
Confirming the CO Line Connection
After the SLC2/LCOT2 card is installed, program the PBX and connect CO lines to the PBX.
If SLC2/LCOT2 card is not installed, this confirmation can be skipped.
To confirm that the CO lines are successfully connected, dial [ ] [3] [7] + CO line number (3 digits) on an IP
telephone, or press the IP telephone's S-CO button. You will hear a dial tone if the CO line is available and
connected.
Document Version 2016-03
4.13 Starting the KX-NS1000
Installation Manual 171