Programming With Built-In Media Relay Gateway - Panasonic KX-NS1000 Installation Manual

8.
Move the mouse pointer over Site Property.
A menu will be shown under the mouse pointer.
9.
Click Main.
10.
Click the Port number tab.
11.
Program the following items according to the protocol used by KX-UT series SIP phones in the remote site.
a.
When the KX-UT series SIP phones are using HTTPS:
•
CWMP (HTTPS) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTPS) Port No. for SIP-MLT
b.
When the KX-UT series SIP phones are using HTTP:
•
CWMP (HTTP) Port No. for SIP-MLT
•
Data Transmission Protocol (HTTP) Port No. for SIP-MLT
Note
For the default port numbers of the KX-NS1000, refer to "8.5 Port Security".
12.
Click OK.
Using a KX-NS1000 as an NTP server
When the KX-NS1000 will be used as a NTP server, follow the procedures below.
1. Click Setup ® Network Service ® Server Feature ® NTP.
2.
Select Enable.
3.
Click OK.
Programming the router at the main site with Built-in Media Relay Gateway
Port forwarding settings (Router – KX-NS1000)
Configure the following items for port forwarding between the Media Relay Gateway and the router.
For the KX-NT500 series:
Application
PTAP
MGCP
RTP (UDP)
Document Version 2016-03
5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
LAN Side Port Number
Signaling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
Signaling (MGCP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
Make sure the RTP Start Port (UDP) and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the KX-NS1000 uses.
For the range of RTP port numbers that the KX-NS1000 uses, refer to "Port
Numbers for Optional DSP Cards" in "8.5 Port Security".
WAN Side Port Number
Signaling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32
—Card Property")
NAT - MGCP Server Port No.
(Use the same value as in step 5 of
"Programming the KX-NS1000 with
Built-in Media Relay Gateway".)
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
*1
Installation Manual 273