Panasonic KX-NS1000 Installation Manual page 225

•
Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on
a remote office LAN
All of the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "5.8.2 Setting VLAN
Parameters" after assigning the IP addresses, without ending programming.
Note
•
By assigning the PBX's IP address to one IP-PT, it is possible to assign the PBX's IP address to
other IP-PTs or IP-CSs on the same LAN through system programming. For details, refer to
"9.15 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Port Property—Option—
Announce Mode" in the PC Programming Manual.
•
IP-PTs can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when IP-PTs are located on several LANs, a DHCP server is required on each LAN.
•
Since the default setting of the DHCP client function is enabled for IP-PTs, simply connect the
IP-PTs to the LAN to use the DHCP server.
Document Version 2016-03
5.8.1 Assigning IP Addressing Information
Installation Manual 225