Section 10 Diagnose Ied Status; Read Internal Events; Find Available Functions - ABB REC670 Operator's Manual

1MRK 511 188-UEN C
Section 10
10.1
10.2
Operator's manual
Diagnose IED status
About this chapter
This chapter describes where in the HMI tree to find the cause of an internal IED
failure and information about the IED as such.

Read internal events

Main menu/Diagnostics/Internal events
Internal events in the diagnostics menu of the HMI tree shows a time stamped list
of events. These are events internal to the IED and can be used as reference when
troubleshooting the system.

Find available functions

Under general in IED status the functional readiness and status of cards and
applications can be viewed.
Main menu/Diagnostics/IED status/General
Messages such as On, Ready and Fail indicate the status of each item on the list.
To identify the type of IED you are confronted with, navigate to identifiers using
the keypad. The path to identity parameters is shown below.
Main menu/Diagnostics/IED status/Product identifiers
Under product identifiers, information about the type of IED, the IED main
function, the serial number of the IED, its order number and production date are found.
By following the menu path below the configuration of all hardware in the IED is
displayed as a list.
Main menu/ Diagnostics/IED status/Installed HW
The list includes the slot number, the module name (Card) and its article number.
By following the menu path below the status signals of the merging units are listed.
Main menu/Diagnostics/IED status/Merging units/MergingUnit:x
The list includes all the status signals of each merging unit.
Section 10
Diagnose IED status
65