Siemens PM-E F pm DC24V PROFIsafe Installation And Operating Manual page 5

Documentation
For integration in the S7
Distributed Safety F-system
STEP 7
manuals
STEP 7
online help
PCS
7 manuals
The entire SIMATIC S7 documentation is available on CD-ROM.
Guide
This manual describes the fail-safe modules of the ET 200S distributed I/O system. It
consists of instructive sections and reference sections (technical specifications and
appendices).
This manual presents the following basic aspects of fail-safe modules:
● Design and use
● Configuration and parameter assignment
● Addressing, assembly and wiring
● Diagnostic evaluation
● Technical specifications
● Order numbers
ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
Brief Description of Relevant Contents
S7 Distributed Safety, Configuring and Programming
The
the following:
Configuration of the fail-safe CPU and the fail-safe I/O
•
Programming of the fail-safe CPU in fail-safe FBD or LAD
•
Depending on which F-CPU you use, you will need the following documentation:
The operating instructions
•
the configuration, installation, addressing and commissioning of S7-300 systems.
CPU 31xC and CPU 31x, Technical Data
The
•
of the CPU 315F-2 DP and PN/DP and the CPU 317F-2 DP and PN/DP and the CPU
319F-3 PN/DP.
Automation System S7-400 CPU Specifications
The
•
functions of the CPU 416F-2 and CPU 416F-3 PN/DP.
ET 200S IM 151-7 CPU Interface Module
The
•
7 CPU.
ET 200S IM 151-8 PN/DP CPU Interface Module
The
•
PN/DP
IM 151-7 CPU.
A separate product information bulletin is available for each applicable F-CPU. The
•
product information bulletins describe only the deviations from the corresponding
standard CPUs.
Configuring Hardware and Communication Connections with STEP 7 V5.x
The
•
describes the operation of the relevant standard tools of
System Software for S7-300/400 System and Standard Functions
The
•
manual describes functions for distributed I/O access and diagnostics.
Describes the operation of
•
Contains information about how to configure and assign parameters for modules and
•
intelligent slaves with
Contains a description of the programming languages FBD and LAD
•
Describe how to operate the
•
with fail-safe modules is integrated in a higher-level control system)
S7-300, CPU 31xC and CPU 31x: Configuration
manual describes the standard functions
manual describes the standard IM 151-
STEP 7
standard tools
HW Config
PCS 7
process control system (required when ET 200S
manual and online help describe
describes
manual describes the standard
manual describes the standard
STEP 7
.
reference
Preface
manual
5