Station Number Setting - Mitsubishi Electric GOT2000 Series Connection Manual

5.5.8

Station number setting

Set each station number so that no station number overlaps.
The station number can be set without regard to the cable connection order. There is no problem even if station numbers
are not consecutive.
■1. Direct specification
When setting the device, specify the station number of the temperature controller of which data is to be changed.
■2. Indirect specification
When setting the device, indirectly specify the station number of the inverter of which data is to be changed using the
16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 200 to 215 on GT Designer3, the value of GD10 to GD25 compatible to the
station No. specification will be the station No. of the temperature controller.
Specification station NO.
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
5 - 22
5.5 Temperature Controller Side Setting
Station
No.3
GOT
Examples of station number setting
POINT POINT POINT
Specifying a station No. between 200 and 215
(Example of specifying the station No. 215)
Step 1.
Set the station No. to "200".
Step 2.
Input "215" to the internal device GD10.
Step 3.
The station No. 215 is specified.
For details, refer to (2) Indirect specification shown below.
Compatible device
GD10
GD11
GD12
GD13
GD14
GD15
GD16
GD17
GD18
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Station Station Station
No.7 No.1 No.15
Specification range
1 to 199
216 to 255
1 to 255
For the setting other than the above, error
(dedicated device is out of range) will occur.
Station
No.6
Setting range