Mitsubishi Electric GOT2000 Series Connection Manual page 186

(For GT21,GS)
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Retry
Startup Time
Timeout Time
Host Address
Delay Time
32 bit Storage
6 - 20
6.2 Serial Connection
Set this item when change the transmission speed used for communication
with the connected equipment.
(Default: 19200bps)
Set this item when change the data length used for communication with the
connected equipment.
(Default: 8bit)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed
during communication.
(Default: Even)
Set the number of retries to be performed when a communication error
occurs.
(Default: 0time)
Specify the time period from the GOT startup until GOT starts the
communication with the PLC CPU.
(Default: 3sec)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the host address (station No. of the PLC to which the GOT is
connected) in the network of the GOT.
(Default: 1)
Set this item to adjust the transmission timing of the communication request
from the GOT.
(Default: 0ms)
Select the steps to store two words (32-bit data).
(Default: Auto)
POINT POINT POINT
(1) Delay Time
When connecting to PLC CP-9200(H) and CP-9300MS, set the following.
CP-9200(H)
CP-9300MS
(2) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(3) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description
Model name
port:0
port:1
Range
4800bps,
9600bps,
19200bps,
38400bps,
57600bps
8bit (fixed)
1bit (fixed)
Even (fixed)
0 to 5times
3 to 30sec
1 to 30sec
1 to 31
0 to 30
( 10ms)
LH Order/ HL Order/ Auto
Delay Time
30ms or more
10ms or more
30ms or more