Table of Contents
Advertisement
RUGGEDCOM RS969
Installation Guide
Each port features a Speed and Link LED that indicates the state of the port.
LED
Speed
Link
The following are the pin-out description for the RJ45 and M12 connectors:
8
Figure 19: RJ45 Ethernet Port Pin Configuration
Figure 20: 4-Pin D-Coded M12 Ethernet Port Pin
Configuration
For specifications on the available copper Ethernet ports, refer to
Section 3.2
Fiber Optic Ethernet Ports
Fiber optic Ethernet ports are available with an LC (Lucent Connector) connector. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Fiber Optic Ethernet Ports
State
Yellow
Off
Yellow (Solid)
Yellow (Blinking)
Off
Pin
1
Description
The port is operating at 100 Mbps
The port is operating at 10 Mbps
Link established
Link activity
No link detected
10/100Base-TX Signal
1
RX+
2
RX-
3
TX+
4
Reserved (Do Not Connect)
5
Reserved (Do Not Connect)
6
TX-
7
Reserved (Do Not Connect)
8
Reserved (Do Not Connect)
Pin
1
2
3
4
Section 4.3, "Copper Data Port
Chapter 3
Communication Ports
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
10/100Base-Tx Signal
TX+
RX+
TX-
RX-
Specifications".
21
Advertisement
Table of Contents
