Table of Contents
Advertisement
Chapter 2
Installing the Device
Figure 3: Panel Mounting (Typical)
1. Flange
2.
Install the supplied screws to secure the flanges to the panel.
Section 2.2
Connecting Power
The following sections describe how to connect power to the device:
• Use only #16 gage copper wiring when connecting terminal blocks.
• Equipment must be installed according to the applicable country wiring codes.
•
Section 2.2.1, "Power Supply Input Connectors Description"
•
Section 2.2.2, "Single High AC Power Supply Wiring Examples"
•
Section 2.2.3, "Single Low DC Power Supply Wiring Examples"
•
Section 2.2.4, "Dual High AC/DC Power Supplies"
6
1
RUGGEDCOM RS969
Installation Guide
Connecting Power
Advertisement
Table of Contents
