GE Grid Solutions
3.3. Configuring the iBox Kit Components
Introduction
Your iBox Kit modules have been pre-configured based on your order. However,
you need to configure, or confirm the configuration of, the following items:
iBox Kit Module
iBox
Ethernet Module
(if equipped)
DC Analog Input
Module (if equipped)
AC Analog Input
Module (if equipped)
Note: Configuration procedures vary for the iBox operating over a serial
GE Information
•
Project properties
•
Device properties
•
Communications properties
•
SCADA protocol addresses
•
PPP Driver (if applicable)
•
User ID and password
•
IP addresses
•
Admin password
•
Pass-through switch
•
Configuration ports setting
In most cases, you will not have to reconfigure the DC
Analog Input Module. You may, however, want to
change the following:
•
Input type (voltage or current)
•
Input range
•
Point descriptors
In most cases, you will not have to reconfigure the AC
Analog Input Module. You may, however, want to
change the following:
•
Point descriptors
connection versus a LAN connection. Be sure to follow the appropriate set
of procedures for your type of connection.
Installation and Maintenance Guide
Configurable Settings
994-0047-5.10-4
iBox/iBox Kit
Continued on Next Page
87