Siemens SINUMERIK 840D sl Operating Manual page 136

Machining the workpiece
6.7 Starting machining at a specific point
Block search mode
Without calculation
With program test
Note
Search mode for ShopTurn programs
● The search variant for the ShopTurn machining step programs can be specified via MD
51024. This applies only to the ShopTurn single-channel view.
References
For additional information, please refer to the following documentation:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
Procedure
136
Meaning
For a quick search in the main program.
Calculations will not be performed during the block search, i.e. the calculation
is skipped up to the target block.
All settings required for execution have to be programmed from the target
block (e.g. feedrate, spindle speed, etc.).
Multi-channel block search with calculation (SERUPRO).
All blocks are calculated during the block search. Absolutely no axis motion
is executed, however, all auxiliary functions are output.
The NC starts the selected program in the program test mode. If the NC
reaches the specified target block in the actual channel, it stops at the begin‐
ning of the target block and deselects program test mode again. After con‐
tinuing the program with NC start (after REPOS motion) the auxiliary func‐
tions of the target block are output.
For single-channel systems, the coordination is supported with events run‐
ning in parallel, e.g. synchronized actions.
Note
The search speed depends on MD settings.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. Select the "Machine" operating area.
2. Press the <AUTO> key.
3. Press the "Block search" and "Block search mode" softkeys.
The "Search Mode" window opens.
Operating Manual, 05/2017, A5E40868721
Turning