Siemens SINUMERIK 840D sl Operating Manual page 184

Machining the workpiece
6.15 Mold making view
Simultaneous view of the program and mold making view
You have the option of displaying the mold making view next to the program blocks in the
editor.
You can navigate back and forth between the NC blocks listed on the left and the associated
points in the mold making view.
● On the left in the editor, if you place the cursor on an NC block with position data, then this
NC block is marked in the graphic view.
● If you select a point on the right in the mold making view using the mouse, then conversely
you mark the corresponding NC block on the left-hand side of the editor. This is how you
jump directly to a position in the program in order to edit a program block for example.
Switch between the program window and the mold making view
Changing and adapting the mold making view
Like simulation and simultaneous recording, you have the option of changing and adapting the
mold making view in order to achieve the optimum view.
● Increasing or reducing the size of the graphic
● Moving the graphic
● Rotating the graphic
● Changing the section
184
Press the <NEXT WINDOW> key if you wish to toggle between the program window
and the mold making view.
Operating Manual, 05/2017, A5E40868721
Turning