Multi-Channel Functionality For Large Operator Panels - Siemens SINUMERIK 840D sl Operating Manual

Parameter
ZI
ZB
XA
XI
N
SW or L
W
L
S
Procedure
11.2.4

Multi-channel functionality for large operator panels

For the large OP 015, OP 019 operator panels as well as at the PC, there is more space in
the "Machine", "Program" and "Parameter" operating areas – as well as in all lists – to display
NC blocks, tools etc.
Further, you also have the option of simultaneously displaying more than 2 channels.
This makes it easier for you to identify the machine situation for machines with 3 and more
channels. Further, it makes it simpler for you to generate and run-in three or four-channel
programs.
Turning
Operating Manual, 05/2017, A5E40868721
Description
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Outside diameter – (only for tube and cylinder)
Inside diameter (abs) or wall thickness (inc) – (only for tube)
Number of edges – (only for polygon)
Width across flats or edge length – (only for polygon)
Width of the blank - (only for centered cuboid)
Length of the blank - (only for centered cuboid)
Speed limitation of the counter-spindle
1. You have created programs for the multi-channel machining in the
job list and the parameter screen "Multi-channel data" is open in
the editor.
2. Enter the data for the cross-channel data.
3. Press the "Accept" softkey.
The multi-channel editor is opened and displays the programs that
have been created.
The cursor is positioned on an empty line before the cycle for the
job list (CYCLE208). You can also enter a comment.
Note:
Note that CYCLE208 must appear within the first 20 lines in job list
programs.
After the cycle call, enter the required initializations for the G code
program and add the program code.
Software options
If you require the option "programSYNC" for the views described here.
Multi-channel machining
11.2 Multi-channel support
Unit
mm
mm
mm
mm
mm
mm
mm
rev/min
607