Selection Of The Cycles Via Softkey - Siemens SINUMERIK 840D sl Operating Manual

Parameters
Parameter Description
Retraction Lift mode
● simple
● Extended
● all
XRA Retraction plane X external ∅ (abs) or retraction plane X referred to XA (inc)
XRI Retraction plane X internal ∅ (abs) or retraction plane X referred to XI (inc)
- (only for retraction "extended" and "all")
ZRA Retraction plane Z front (abs) or
retraction plane Z referred to ZA (inc)
ZRI Retraction plane Z rear – (only for retraction "all")
Tailstock Yes
● Tailstock is displayed for simulation / simultaneous recording
● When approaching/retracting, the retraction logic is taken into account
No
XRR Retraction plane – (only "Yes" for tailstock)
Tool change point Tool change point
● Work (Workpiece Coordinate System)
● Machine (Machine Coordinate System)
XT Tool change point X
ZT Tool change point Z
SC Safety clearance (inc)
Acts in relation to the reference point. The direction in which the safety clearance is
active is automatically determined by the cycle.
S1 Maximum speed, main spindle
Machining Milling direction:
direction
● Climbing
● Conventional
9.14

Selection of the cycles via softkey

Overview of the machining steps
The following machining steps are available.
Turning
Operating Manual, 05/2017, A5E40868721
Creating a ShopTurn program
9.14 Selection of the cycles via softkey
Unit
mm
mm
mm
mm
mm
mm
mm
mm
rev/min
261