The following views are available:
● Side view
● Half cut view
● Face view
● 3D view (with option)
● 2-window
● Machine space (with option)
7.5.1
Side view
Displaying a side view
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
7.5.2
Half section
Displaying a half cut view
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
Turning
Operating Manual, 05/2017, A5E40868721
1.
Simultaneous recording or simulation is started.
2.
Press the "Side view" softkey.
The side view shows the workpiece in the Z-X plane.
1.
Simultaneous recording or simulation is started.
2.
Press the "Further views" and "Half cut view" softkeys.
The half cut view shows the workpiece cut in the Z-X plane.
Simulating machining
7.5 Different views of the workpiece
203