Siemens SINUMERIK 840D sl Operating Manual page 742

Managing programs
14.17 Setup data
Even tool data that you have measured on an external tool setting station can be copied easily
into the tool management system using this option.
Backing-up job lists
If you wish to backup a job list, which contains ShopTurn and G code programs, you obtain
dedicated selection boxes to backup the tool data and zero points.
Note
Backing up setup data from part programs
Setup data from part programs can only be backed up if they have been saved in the
"Workpieces" directory.
For part programs, which are located in the "Part programs" directory, "Save setup data" is
not listed.
Backing up data
Data
Tool data
Tool data for ShopTurn
programs
-- only available for job list
with ShopTurn and G
code programs
Tool data for G code pro‐
grams
-- only available for job list
with ShopTurn and G
code programs
Magazine assignment
Zero points
Zero points for ShopTurn
programs
-- only available for job list
with ShopTurn and G
code programs
742
● No
● All used in the program (only for ShopTurn program and job list only
with ShopTurn programs)
● Complete tool list
● No
● All used in the program
● Complete tool list
● No
● Complete tool list
● Yes
● No
● No
The selection box "Basis zero point" is hidden
● All used in the program (only for ShopTurn program and job list only
with ShopTurn programs)
● All
● No
The selection box "Basis zero point" is hidden
● All used in the program
● Complete tool list
Operating Manual, 05/2017, A5E40868721
Turning