Lenovo ThinkSystem SR650 Maintenance Manual page 207

Where:
xcc_internal_ip
The BMC/IMM/XCC internal LAN/USB IP address. The default value is 169.254.95.118.
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Notes:
1. BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are all
valid for this command.
2. If you do not specify any of these parameters, OneCLI will use the default values. When
the default values are used and OneCLI is unable to access the Lenovo XClarity
Controller using the online authenticated LAN access method, OneCLI will
automatically use the unauthenticated KCS access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted): You do not need to specify a
value for access_method when you use this access method.
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
The following commands are examples of not using the user ID and password default
values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access Lenovo XClarity Controller
using the LAN from a client, the host and the xcc_external_ip address are required
parameters.
[−−imm xcc_user_id:xcc_password@xcc_external_ip]
or
[−−bmc xcc_user_id:xcc_password@xcc_external_ip]
Where:
xcc_external_ip
The BMC/IMM/XCC LAN IP address. There is no default value. This parameter is
required.
xcc_user_id
The BMC/IMM/XCC account (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
.
Chapter 3 Hardware replacement procedures
199