Cutting Media - Epson SC-F9300 series User Manual

SC-F9300 Series User's Guide
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.

Cutting Media

Caution:
❏ The heater may be hot; observe all necessary
precautions. Failure to observe the necessary
precautions could result in burns.
❏ When cutting media, be careful not to cut
your fingers or hands with the cutter or other
blades.
A
Press the M button, select Feed To Cut
Position, and then press the Z button.
The trailing edge of the print is fed to the cut
position (cutter groove).
If you have printed the amount of media
remaining, press the u button to rewind the
media until this information appears on the roll
side beyond the cutter groove so that it will
remain on the roll after the media is cut.
Basic Operations
B
Raise the cutter, and then move it so that the
cutter blade fits the cutter groove properly.
If you cannot position your hand correctly due
to the front cover, open the front cover and
then cut.
c
Important:
When you cut the media, check that it does
not rise up inside the front cover or has not
come free from the media edge plate before
printing.
43