Table of Contents
Advertisement
SC-F9300 Series
User's Guide
If no other parts need to be cleaned, proceed to the
following section.
"Finishing Cleaning" on page 65
U
Finishing Cleaning
After cleaning is complete, close the right-side
maintenance cover and press the Z button.
The menus will close when the print head returns to
its normal position.
To continuously make prints, perform Nozzle Check.
"Printing nozzle check patterns" on page 81
U
Disposing of used ink cleaner, cleaning sticks, and
clean-room wipers U
"Disposal of used
consumables" on page 80
Ink refill
Time Period for Ink Refills
Immediately take care of the following two points
when Check Ink Levels message is displayed on the
control panel screen.
❏ Prepare an ink pack of the appropriate color.
Maintenance
❏ Check the level of the ink. If the remaining ink is
70 mm or less from the bottom of the ink tank,
replace the chip unit and refill the ink.
Printing cannot be done if even one color is Charge
Expended or Refill Ink Tank. If the Check Ink Levels
message is displayed during a print job, you can
replace the chip unit and refill the ink while printing
continues.
Ink Packs Compatible with this PrinterU
and Consumable Products" on page 117
c
Important:
This printer has a remaining ink warning system.
Information about the available amount of ink in
one pack is recorded in the chip unit supplied with
a new ink pack. This information is written to the
printer when the chip unit is mounted on the
printer.
The ink remaining warning system estimates the
remaining ink based on the ink usage conditions
and the information written to the printer about
the available amount of ink in one pack, and then
displays a message.
To maintain the accuracy of this system, replace
the chip unit and refill the ink as soon as possible
once the remaining ink is 70 mm or less from the
bottom of the ink tank.
Writing the information about available amount of
ink in one ink pack when a chip unit is installed on
the printer is called "charging".
After charging, the chip unit that was mounted on the
printer is no longer needed. If you replace it with the
chip unit attached to a new ink pack, charging will be
done automatically when required.
Installing a new chip unit on the printer to do
automatic charging is called "Reserving".
Reserving can be done at any time if the indicator's
level for the estimated amount of ink is between 1 and
6.
65
"Options
Advertisement
Table of Contents
