Epson SC-F9300 series User Manual page 54

SC-F9300 Series User's Guide
*2 By selecting No Margin in Margin Between Pages in the settings menu for the printer, you can adjust the
margins in a range between -10 mm and +10 mm.
*3 This may be available in the RIP depending on the RIP software being used. Contact the RIP manufacturer
for more information.
*4 Note the following points when setting margins.
❏
Leave margins of 10 mm or more when using media edge plates. Narrower margins could result in printer printing
over the plates.
❏
If the total of the print data width and set left and right margins exceeds the printable area, a portion of the data will
not be printed.
Note:
If the following points are not observed when Media Size Check is Off, printing may occur outside the left and right
edges of the media. Ink used outside the edges of the media will stain the inside of the printer.
❏ Ensure that the print data width does not exceed the loaded media width.
❏ When media is loaded to the left of the right side reference position, align the Print Start Position setting with the
position where the media set.
"The Printer Setup Menu" on page 99
U
Basic Operations
54