Canon CLC5151 Reference Manual page 58

1
1-18
Main Power and Control Panel Power
The screen below is displayed when the machine is ready to scan.
The machine is ready to scan in approximately four minutes (for the CLC5151) or five
minutes (for the CLC4040/iR C4580i/iR C4080i) after the screen above appears (at a room
temperature of 20°).
NOTE
• Once the message <Reservation copies can be made.> appears on the touch panel display, you
can specify settings, and copying or printing begins automatically as soon as the machine
finishes warming up. (See Chapter 1, "Introduction to the Copying Functions," in the Copying and
Mail Box Guide.)
• In the case above, the standard settings are selected.
• The standard copy settings are:
- Copy Ratio: 1:1 (100%)
- Paper Selection: Auto Paper Selection
- Copy Exposure: Manual Exposure Adjustment
- Copy Quantity: 1
- Colour Mode: Auto-Color Select (for the CLC5151/CLC4040) or Black (for the iR C4580i/
iR C4080i)
- Copy Function: 1 1-sided copy
• The standard settings for each function of the machine (Copy, Mail Box, Send, and Fax) are
already set at the factory, but you can change them to suit your needs. (See Chapter 8,
"Customizing Settings," in the Copying andMail Box Guide, and Chapter 9, "Customizing
Communications Settings," in the Sending and Facsimile Guide.)
• You can select which functions to display on the Basic Features screen when turning ON the
main power, according to the Additional Functions settings. (See "Initial Function at Power ON,"
on p. 4-25.)
• If you press [ ] on the Basic Features screen right after the machine is activated, the screen will
be blank. Wait for a moment, and then press [ ] again.
• If a Macintosh, which has been shut down, is connected to the machine via a USB cable, when
you turn the machine ON, the Macintosh may also turn ON. In this case, disconnect the
Macintosh from the machine. (You may also be able to solve this problem by using a USB hub
between the machine and the Macintosh).