Dlr/A 4.8.1.1 - ABB i-bus KNX Product Manual


ABB i-bus KNX
Device technology
2.1

DLR/A 4.8.1.1

2.1.1 Technical data DLR/A 4.8.1.1
Supply
DALI output
Sensor inputs
Connections
Brightness detection
12 2CDC507128D0202 | DLR/A 4.8.1.1
light controller supply voltage
Power consumption total via mains
Current consumption total via mains
Leakage loss total for device
KNX voltage
Current consumption KNX
Power consumption via KNX
Number of outlets
Number of DALI devices
Number of lighting groups
Distance between DLR/A and last DALI device
2
Cable cross-section 0.50 mm
0.75 mm
1.00 mm
1.50 mm
Light Sensor LF/U 2.1
Number of inputs
Max. cable length per sensor
KNX, DALI, Light Sensor, line voltage
Tightening torque
Lighting control operating range
100...240 V AC (+10 %/-15 %)
85...265 V AC, 50/60 Hz
110...240 V DC
Maximum 3.5 W at 230 V AC and max. load
Maximum 15 mA at 230 V AC and max. load
Maximum 1.6 W at 230 V AC and max. load
21...31 V DC
Maximum 10 mA
Maximum 210 mW
1 to DIN EN 62386 (Part 101 and 102)
The DALI output is a fixed 230 V, i.e.
unintentional application of the light controller
supply voltage will not cause destruction of the
DALI output.
Maximum 64
8
2)
100 m
2 2)
150 m
2 2)
200 m
2 2)
300 m
Detailed information
page 18
4
Per light sensor 100 m, Ø 0.8 mm,
P-YCYM or J-Y(ST)Y cable (SELV),
e.g. shielded KNX bus cable
Plug-in screw terminals:
0.2...2.5 mm
2
single core or stranded
0.2...2.5 mm
2
ferrules
0.2...1 mm
2
2 rigid conductors, same cross
section
0.2...1.5 mm² 2 flexible conductors, same cross
section
Maximum 0.6 Nm
optimized for 500 Lux.
200 ..1200 Lux for rooms with average furnishing
level degree of reflection 0.5
max. 860 Lux in a very brightly furnished room
(reflection 0.7)
max. 3000 Lux in a very darkly furnished room
(reflection 0.2)
The Lux values are measured values on the
work surface (reference surface)
1)
1)
1)
Light Sensor LF/U 2.1,
3)
.