A.5 Code Table Status Sensors (No. 9) - ABB i-bus KNX Product Manual


ABB i-bus KNX
Appendix
A.5 Code table Status sensors (No. 9)
The status of the 4 light sensors is visible with this communication object. If a light sensor provides a
changed sensor value within a time of 5 seconds, the DALI Light Controller assumes that a light sensor is
not connected or the light sensor is defective.
A missing sensor signal is indicated by a 0 in the corresponding bit of the communication object Status
sensors (No. 9).
The lowest bit (bit number 0) indicates the status of light sensor A (1). Bit number 3 indicates the status of
light sensor H (4).
The following code table shows you the status of all light sensors based on the hexadecimal or decimal
values read from the communication object Status sensors.
200 2CDC507128D0202 | DLR/A 4.8.1.1