Siemens SIWAREX FTA Device Manual page 111

Weighing electronics for automatic scale
Table of Contents

Advertisement

Name
Selection for type of
BYTE
controller
Control factor
BYTE
Proportional controller
Reserve 5a
BYTE
Maximum one-time
REAL
control access
Controller optimum Plus
REAL
Controller optimum Minus REAL
Set value for fine time
TIME
Control factor fine time
BYTE
controller
Reserve 6
BYTE
Empty
Reserve 7
WORD
Overlapping time
TIME
Emptying time
TIME
Maximum emptying time
TIME
Filling
Filling with coarse
BYTE
Reserve 8
BYTE
SIWAREX FTA
Type
Address
Default
DBB061
0
DBB062
30
1
0
DBD064
1
DBD068
0
DBD072
0
DBD076
3000
DBB080
20
DBB081
0
DBB082
0
DBD084
0
DBD088
0
DBD092
2 sec
DBB096
0
DBB097
0
Range of Values / Explanation
Bits 1 to 7 not used
0: No control for switching off the rough-/fine-signal
1: Proportional controller without fine signal time
controller
2: Proportional controller with fine-signal time
controller
3: Fine signal time controller without proportional
controller
Other definitions not permitted.
[0...100 %]
Other definitions not permitted.
Reserve 5a
Limitation for maximum one-time control access
of proportional controller
0...WR
max
0...WR
max
Definition of set time for the fine signal-time controller
0...100 [%]
Other definitions not permitted.
Reserve 6
Reserve 7
The overlapping time must be less than the
emptying time The next scale start can be
performed early by the amount of overlapping
time, while emptying
0: Emptying depending on empty range
>0: Empty after defined time
0: Monitoring switched off
>0: After the emptying time has elapsed and the
empty range has not been achieved, a technology
error is output
0: All weighing procedures in the loading
operation are controlled with coarse and fine
signal
1: The last 5 weighing procedures are run with
coarse and fine signals
2: The last 4 weighing procedures are run with
coarse and fine signals
4: The last 3 weighing procedures are run with
coarse and fine signals
8: The last 2 weighing procedures are run with
coarse and fine signals
16: The last 1 weighing procedure is run with
coarse and fine signals
Other values are not used
Reserve
Weighing Functions
Reference
5.16.29
5.16.30
5.16.31
5.16.32
5.16.33
5.16.35
5.16.36
5.16.37
5.16.38
5.16.39
5-99

Advertisement

Table of Contents
loading

Table of Contents