Table of Contents
Advertisement
Messages and Diagnostics
Error
Data and
No.
command errors -
description
105-
Plausibility error
110
Base parameter
105
Weighing operating
mode not allowed
or unknown
106
Limit values
implausible
107
108
109
110
111-
Plausibility error
135
Weighing
parameter
111
Number tare-zero
position cycles not
allowed
112
Value for control
weighing pauses
incorrect
113
Empty overlapping
time too long
114
Min.-/Max.-tare
implausible
115
Log text No.
assignment for
automatic logging is
incorrect
116
Operating mode not
allowed or unknown
117
Fine time too short
118
Tolerance range
implausible
119
120
121
122
123
124
125
126
127
128
129
130
131
7-146
Solution
Weighing operating mode in DR 4 is not correct. Enter a correct
weighing operating mode.
The default limit values in DR 4 are not plausible. Limit value 3
may only be operated as a max-limit value (On ≥ Off). Correct
limit value 3.
Reserved
Reserved
Reserved
Reserved
The number for the tare/zero definition cycle is incorrect
(max. 100). Enter a correct value.
The default for pauses between the control weighing procedures
is incorrect (max. 100). Correct the definition.
The emptying overlap time in DR 23 is too large. The maximum
may only correspond with the emptying time that is defined there.
The limits for tare in DR 23 are not plausible. Tare minimum and
maximum weight may not be less. The tare maximum weight
must be larger than the minimum weight. Correct the entry.
The log text number in DR 23 is incorrect.
Correct the number (0...4).
The default for the tare/zero setting mode in DR 23 is incorrect.
Correct the default (0..4).
Fine time must be greater than Inhibition time Fine.
Correct the default in DR 23.
The default for tolerance ranges TO1, TU1, TO2, TU2 must be
corrected. TU2 must be greater than TU1 and TO2 greater than
TO1. Check parameter definitions in DR 22.
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
SIWAREX FTA
Advertisement
Table of Contents
