Siemens RUGGEDCOM WiN5200 User Manual page 48

Chapter 5
Equipment Configuration and Monitoring
Table: Scanner Table fields
Field
Priority
Bandwidth [MHz]
Start frequency
[kHz]
Step [kHz]
End frequency [kHz]
NOTE
The frequency and bandwidth should match the base station configuration.
5.
To remove a row from the table, select the row and click the
After making changes to the Scanner Settings table, click the Apply button.
6.
7. To begin transmitting, click the Connect button.
8. Click the Network button. The IP Settings pane appears.
Figure 35: IP Settings pane
9. Configure the CPE IP addresses in the following fields:
Table: IP Settings fields
Field
Configured LAN IP
Address
Configured LAN
Mask
40
Description
Sets the scanning priority.
Sets the scanning bandwidth.
Values: 3.5 MHz | 5 MHz | 7 MHz | 10 MHz
Sets the start of the scanning range.
Sets the scanning step.
Sets the end of the scanning range.
Description
Sets the CPE LAN IP address. Use this address for local CPE management through a direct connection
between the CPE and a computer.
Sets the CPE LAN subnet mask.
button. The row is removed from the table.
RUGGEDCOM WiN5100/WiN5200
User Guide
Configuring the CPE