Cpe Statistics; General Statistics - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 6
CPE Management Interface
Field
Status
Type
5. In the Access List Table, you can add preprovisioned entries to the list. Self-learned entries appear in the
list automatically.
a. Click the
b. Type an IP address in the new row.
6. To remove a MAC Address, select a row and click the
removes the last entry in the table.
7. Click the Apply button.
Section 6.4

CPE Statistics

This section describes how to:
• view general CPE system statistics. See
• view CPE hardware information. See
• view and clear CPE RF statistics. See
• view and clear network statistics. See
• view and clear service flow statistics. See
Section 6.4.1

General Statistics

On the the General Statistics pane, you can review general CPE status and information. The General Statistics
pane is read-only; there are no parameters to set on this pane.
Procedure: Viewing General Statistics
Click the Statistics button. The General Statistics pane appears.
1.
80
Description
Displays the Status. Sticky addresses remain in the table after a reboot. Non-Sticky
addresses are cleared from the table after a reboot.
Values: Sticky | Non-Sticky
Displays Self-Learned Entries.
Values: Self-Learned | Preprovisioned
button. A new row appears in the Access List Table.
Section 6.4.1, "General
Section 6.4.2, "Device
Section 6.4.3, "RF
Section 6.4.4, "Network
button. If no rows are selected, clicking the
Statistics".
Info".
Statistics".
Statistics".
Section 6.4.5, "Service Flow
RUGGEDCOM WiN5100/WiN5200
Statistics".
User Guide
button
CPE Statistics