Managing System Functions - Siemens RUGGEDCOM WiN5200 User Manual

Chapter 6
CPE Management Interface
Section 6.2.1

Managing System Functions

The System Function pane displays the CPE name and provides general system controls. On this pane, you
can change the CPE password, connect to and disconnect from the base station, reboot the CPE, log out from
the management interface, and restore the CPE to its factory default settings.
Procedure: Accessing the System Functions pane
1. Click the Management button. The System Functions pane appears.
Figure 40: System Functions pane
2. The following operations can be performed from this pane:
• Set the CPE name: The CPE name appears at the top of many of the management interface panes,
identifying the CPE unit as you work with the management interface. In the CPE name field, type a name
and click the Apply button. The CPE name appears in the at the top of the management interface panes.
• Link Watchdog: You can set the Link Watchdog function to reset the device if it is not in an operational
state for a continuous time. In the Link WatchDog field, select Disabled, Smart or Always and click the
Apply button. The default setting is Smart.
• Link Timeout (min): You can change the number of minutes before the Link Watchdog function times
out. In the Link Timeout (min) field, enter the number of minutes and click the Apply button. The default
setting is 15.
• Change the CPE password: You can change the password used to log in to the CPE management
interface. For more information, see
• Connect the CPE to the base station: To begin broadcasting and connect to the base station, click the
Connect button.
46
Section 6.2.2, "Changing the CPE Management Interface
RUGGEDCOM WiN5100/WiN5200
User Guide
Password".
Managing System Functions