Epson WorkForce Pro WF-4720 series User Manual page 129

User's Guide
❏ Density
Sets the density of the outgoing fax.
❏ Remove Background
Detects the paper color (background color) of the original document, and removes or lightens the
color. Depending on the darkness and vividness of the color, it may not be removed or lightened
❏ ADF Continuous Scan
When sending a fax from the ADF, you cannot add originals in the ADF after starting scanning. If
you place different sized originals in the ADF, all of the originals are sent at the largest size among
them. Enable this option so that the printer asks if you want to scan another page after an original in
the ADF has finished scanning. Then you can sort and scan your originals by size and send them as
a single fax.
Fax Send Settings:
❏ Direct Send
Sends monochrome faxes to a single recipient as soon as the connection is made, without saving the
scanned image to memory. If you do not enable this option, the printer starts the transmission after
saving the scanned image to memory and may cause a memory full error when sending many pages.
By using this option, you can avoid the error, but it takes longer to send the fax. You cannot use this
option when sending a fax to multiple recipients.
❏ Send Fax Later
Sends a fax at a time you specified. Only a monochrome fax is available when using this option.
❏ Add Sender Information
❏ Add Sender Information:
Select the position where you want to include the header information (sender name and fax
number) in the outgoing fax, or not to include the information.
Select Off to send a fax with no header information.
Select Outside of Image to send a fax with header information in the top white margin of the fax.
This keeps the header from overlapping with the scanned image, however, the fax received by the
recipient may be printed across two sheets depending on the size of the originals.
Select Inside of Image to send a fax with header information approximately 7 mm lower than the
top of the scanned image. The header may overlap with the image, however, the fax received by
the recipient will not be split into two documents.
❏ Fax Header:
Select the header for the recipient. To use this feature, you should register multiple headers in
advance.
❏ Additional Information:
Select the information you want to add.
❏ Transmission Report
Prints a transmission report automatically after you send a fax. Select Print on Error to print a
report only when an error occurs.
❏ Clear All Settings
Restores all settings in Fax Settings to their defaults.
Faxing
129